If you’ve recently purchased a Ford Explorer, chances are it comes equipped with a Tire Pressure Monitoring System (TPMS) that constantly monitors the psi readings in all four tires. This system uses sophisticated sensors attached to the valve stems to provide accurate tire pressure information. However, after a tire rotation, you may notice that your TPMS display is showing incorrect tire positions. In such cases, it is necessary to reset the Tire Pressure Monitoring System and retrain it to recognize the new positions of the tire sensors. In this comprehensive guide, we will walk you through the step-by-step process of resetting the TPMS on your Ford Explorer.
Getting Started
Before you begin the TPMS reset procedure, it is important to ensure that you have the necessary tools and a safe location to perform the task. You will need access to an air pump, and it is recommended to drive your vehicle above 20 mph for at least two minutes before starting the process.
Part 1: Activating Tire Pressure Monitoring System Reset Mode
To initiate the TPMS reset, follow these steps:
- Place the ignition in the off position and keep the key in the ignition.
- Without starting the engine, turn the key to the ON position.
- Quickly switch the hazard flashers on and then off three times.
Once your vehicle enters the TPMS reset mode, you will hear the horn sound once, and a message will appear in the information display. If you do not hear the horn or see the message, repeat the sequence.
Part 2: Re-Training Your Tire Pressure Sensors
After activating the TPMS reset mode, it’s time to re-train each of your vehicle’s tire pressure sensors. Follow these steps:
- Decrease the air pressure in the driver-side front tire until the horn sounds once.
- Decrease the air pressure in the passenger-side front tire until the horn sounds once.
- Decrease the air pressure in the passenger-side rear tire until the horn sounds once.
- Decrease the air pressure in the driver-side rear tire until the horn sounds once.
- Turn the ignition off.
If you hear two short horn beeps at any point during the re-training process, it indicates an unsuccessful reset procedure. In such cases, please repeat the sequence starting from Part 1 to activate the TPMS reset mode.
Additional Tips and Precautions
- It is crucial to ensure the safety of yourself and others while performing the TPMS reset procedure. Always park your vehicle in a safe location away from traffic.
- Make sure to have a reliable air pump nearby to adjust the tire pressure as needed during the re-training process.
- If you encounter any difficulties or have questions, it is recommended to consult the owner’s manual or contact your local Ford dealership for assistance.
Conclusion
By following the step-by-step guide outlined in this article, you can successfully reset the Tire Pressure Monitoring System on your Ford Explorer. Maintaining proper tire pressure is essential for optimal performance, fuel efficiency, and safety. Regularly checking and resetting the TPMS ensures that you have accurate tire pressure readings, allowing you to enjoy a smooth and worry-free driving experience. Remember to always refer to the specific instructions provided in your vehicle’s manual and consult professionals when needed.
Disclaimer: The information provided in this article is for educational purposes only. Always refer to the official documentation and consult professionals for specific instructions related to your vehicle model.